OctoPi (RPi 2/B+) Enclosure for Lulzbot Mini

thingiverse

This is an enclosure for a Raspberry Pi 2 or B+. The base hooks onto a Lulzbot Mini, just over the controller compartment, and the pegs fit into the front most screw holes. The only screws you'll need are to assemble the enclosure. Print Settings Rafts: No Supports: No Notes: I printed mine with PLA. No raft or supports needed. All I had to do was clean up one piece of sagging filament under the hook. Post-Printing Assembly instructions Place the RPi upside down into the cover. Line up the spacer with the screw holes, so there's a gap between the X and RPi. Position the cover so the hook is facing the ethernet port of the RPi. A portion of the bottom of the RPi should still be visible.