Octopus/Octopus pro mount and cover

thingiverse

Mounting system I made for my Octopus Pro, will fit a RPi 4B (and likely others) on top, use a short USB cable to neatly connect the two. Bottom is printed, top I cut from Aluminium plate but you can also no doubt print it or cut from something else. to connect the top plate and mount, use Male/Female m3 hex standoffs - how long depends on height of your driver heatsinks but ~30mm isn't a bad guess. Fans are 40mm, personally I wired them all up in parallel on the faceplate and have a single wire going to fan port, but you do you! Mount is designed to be mounted from behind on the electronics panel of the V-core - just temporarily stick the mount to the panel and mark the holes, drill through and then you can insert screws through which keeps the other side looking tidy.