Octopus Phone Holder

thingiverse

This is an octopus-inspired phone holder. There are two little wave-like pieces in the front of the base that will prevent the phone from slipping forward when leaning against the front tentacles. The distance between the two is about 3cm. The assembly consists of technically three parts. An octopus head part, a base part, and a tentacle part that is printed six times. From top to bottom the assembly is about 5.5cm. The The tentacles are 1.2cm in diameter at the base and 4.4cm in height. It was made using a loft and the suckers were made using linear pattern with guide curves. The octopus head is 4.9cm tall and made of a loft and some revolves. The base is a circle that is 13cm in diameter. It is 0.5 cm thick not including the front waves. Within the base are flat areas in which there are pegs so that the octopus head and tentacles (which have cut extruded slots) can fit into it.