Oculus Quest 2 Elite Strap Battery Box for Anker PowerCore10000

prusaprinters

<p>This holds an Anker PowerCore10000 power bank onto the collection of Elite Strap clones here for the Oculus Quest 2. I found other solutions for holding the power bank too hard to use.</p> <p>I didn't have any good rubber bands, and wasn't about to waste a zip-tie.</p> <p>I slightly enlarged the retaining tabs over what I printed for myself (V6) - let me know if you cannot get the battery in.</p> <p>Print this in TPU!</p> <p>Remixed for use with:</p> <p>www.thingiverse.com/thing:4636924</p> <p>www.thingiverse.com/thing:4629958</p> <p>www.thingiverse.com/thing:4635406</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>I3 MK3S</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.2</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>12</p></div> <p><strong>Filament:</strong> Any TPU Any/Black/White</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>I printed with "detect bridging perimeters" off in Prusa Slicer, sometimes, TPU will not come off supports without a larger gap when that's on.</p></div> Post-Printing ============= <p>After printing, remove from bed.</p> <p>Tip the support for the square 'dovetail' away from the case, it should come right off, and you can push the small support over the button hole out similarly.</p> <p>At the top of the print, there are two semi-circles that should have one sparse layer I cut those out with a razor, though side clippers will also work. I've shown where to cut in red.</p> <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/9c/53/c9/b9/d1/IMG_20210105_142529_2.jpg"/></p> <p class="detail-caption"><strong>Trim Here with Razor to remove print aid.</strong></p> </p></p></p> Category: Gadgets