Odrive Case with Cooling Fans

thingiverse

A remix of a case for the Odrive motor controller board. https://odriverobotics.com I added connections for 30mm cooling fans. There are two version of the top, one with 3 fans, which is a little bit taller, and one for 3 fans that still lets you use the pins on the board. The fans can get plugged into the 5V pin & ground pins on the board. The holes are sized for 6-32 screws. I drilled with a 7/64 drill bit and then tapped the PLA. You'll need 1" long screws for the 3-fan top. I also added large tabs on the sides for bolting down using 1/4-20 hardware, alternately you could drill through the corner holes in the case and use 4-40 or 6-32 hardware to attach the box and cut off the tabs.