Off-Set Cube

thingiverse

A customizer designed object is now available. The original design is found at http://www.thingiverse.com/thing:56574, created with a powerful tool that allows for endless possibilities, the Customizer. The following settings have been used: Instructions are listed below: * A zero target z-angle was set * A -1 target y-offset was selected * The object has been scaled up three times * The explode distance is set to 30 units * Zero target x-angle has been applied * Cylinder height has reached a new milestone at sixty units high * A bottom layer offset of zero has been made official * One and done when it comes to round edges see warning * Target shape resolution sits comfortably at five points sharp * Target y-angle is spot on at zero degrees * Zero target x-offset is where it's at * The extend donor cube factor is set at two full power * Target shape radius 2 has achieved its ultimate goal of forty units across the board * Setting one for Target Shape Radius 1 reached 40 points * No adjustments were made to the top layer offset - it stays true and steady at zero. * Target Z offset sits smoothly in place at an unbeatable Zero * Last but certainly not least, the object has taken shape with the setting of four