OGX360 T4.1 (snap-fit Case)

thingiverse

This is a remix of madmon's OGX360_T4 case: https://www.thingiverse.com/thing:4913546 Changes: - I made the case 2mm longer so that a micro SD card fits into the SD slot in the Teensy. This is required for the Xbox Memory Unit emulation (must be activated in the code before flashing). - I made the inner walls a little tighter because the Teensy and the USB socket were very loose in the housing. Additional supports have been added to the lid, which also hold the Teensy and the USB socket in position. - Added a snap-fit mechanism into the case. The lid snaps into place well in the lower case and no longer needs to be glued. Attention: Not all USB-A sockets fit the housing! I used these here: https://www.lcsc.com/product-detail/_Jing-Extension-of-the-Electronic-Co-_C65604.html Other sockets might still be too big. With the USB-A socket, the right GND contact must be cut off the housing. The left contact can be connected to the second GND contact of the Teensy. I printed the case in 0.16mm layer height.