Oil Catch Can with 20mm O.D Tubes

cults3d

Wanted an Oil catch can for my car so made this version. The pipes are 20mm outer diameter and 18mm inner diameter. Make sure to print this with a high temp filament and a higher printing temp for good layer adhesion, I used PETG and it has held up no problem . I’d recommend not putting it too close to the engine. You may want to use a high temp spray paint or similar to seal it although depending on your printer setup you should get away without having to if your layers are good and sealed. I didn’t use any on mine, just straight of the printer into the engine bay.