OLED bezel for Maplin PSU box

thingiverse

OLED Bezel for Maplin vented PSU boxes such as: http://www.maplin.ie/p/vented-psu-enclosure-7-n09khhttp://www.maplin.co.uk/p/vented-psu-enclosure-8-n10kh The bezel fits in the opening for the power plug (I usually mount the display in there along with a raspberry pi). It fits the 4-pin I2C 128x64 OLED display boards I've got. Of course many of them are different so it may not fit yours. I was going to "melt down" the 4 stems going through the screw holes (flattening them with a hot iron to fix the display in place) but it wasn't really necessary because it's pretty tight as it is. It will need to be superglued in the enclosure though (I usually glue them to either the top or bottom half, not both obviously, unless you never want to open it again :) ) Unfortunately the displays I've got are no-name so I don't know where to get them again. Make sure this fits yours (a micro caliper is your friend, as always). The opening in the bezel only shows the visible part of the display. The rounded edges actually need to be a little more rounded, it fits OK like this but it could fit a little bit better. Didn't get a chance to update the design though, will upload here if I do.