OLED remote mount for Nullbits Scramble

thingiverse

This is a remote mount option for an OLED on the Scramble macropad from Nullbits. BOM: - Scramble macropad - OLED for scramble - This model printed - 4-pin 90 degree 2.54mm header - 4-pin 2.54mm female to female dupont cable - (optional) heatshrink - (optional) braid My approach was to : - Solder the 4-pin 90 degree 2.54mm header onto the OLED with the pins orientated across the OLED PCBA</li> - Place assembly into the OLED mount on the print</li> - Cut dupont cable to length. ( approx 11.5 cm fro tip of connector to end of wire ) NOTE: Attach optional heatshrink and braiding at this point , if you are using any ) - Solder dupont cable ends to VCC, GND, SDA and SCL. Note order of cabling , this will need to match the order on the OLED I used the following color code corresponding to the cable I purchased and the orientation of the signals on the header: White - GND ( usually denoted with a triangle on the connector ) Yellow - VCC Black - SCL Red - SDA - Run cable between the underside of the scramble PCBA and the print. - Attach the female connector to the 4-pin 90 degree header.</li> Make sure to place pin 1 ( GND) onto GND header pin ( silked on the Nullbits branded OLED , YMMV )