OLED Wemos D1 Mini Wedge (run Octoprint monitor or weather display)

thingiverse

Please post a make if you make this! :) Demo of print status screens: https://imgur.com/a/yX2dhjJ Compact Case for Wemos D1 mini wifi ESP8266 with 0.96 Inch Yellow and Blue I2C IIC Serial 128X64 OLED Display. Uses (1) 10mm M3 screw for assembly. Redesigned side cover to include a lever to be able to press the D1 mini reset button. Sometimes I need to reset my D1 mini and this makes it easier than unplugging and plugging back in. <a href=https://www.aliexpress.com/af/22-AWG-3-pin-RGB-cable.html>Used this wire - great for projects!</a> I used Ziro marble PLA to print this one. A few examples of what you can use this for(hardware and software links within): (4) wire connections documented in the below software links. Octoprint software: https://www.thingiverse.com/thing:2884823 Weather software: https://www.thingiverse.com/thing:857858 I wanted as small of a case as I could have with an upright display view to put on my desk. You need to bend over the (4) pins so they clear the D1 mini(see pic) or just unsolder the 4 pin connector and remove it and solder the wire directly to the board. I found that bending one pin at a time avoid torquing the connection too much. To ensure a minimal gap between the body and cap, sand the surfaces of both the body and side panel flat where they contact each other.