Omega Headphone stand - Voronoi style

thingiverse

Omega headphone stand, voronoi style. Designed for larger headphones with earpads up to 11 cm. The STL I uploaded has a little bit thicker material than the picture I uploaded, because it was a little bit more flexible than I anticipated. (The headphones in the picture are Philips Fidelio X1) Instructions You need a print bed of at least 20 cm. If your bed is smaller you could scale it, but no guarantees that your headphones will fit. To print this, you'll probably need to use some form of support, which can be hard to remove. Printed on my Zortrax M200 using these settings: Material: Z-ABS, black Layer height: 0,29 mm Support: 10 degrees (20 degrees would probably have given a cleaner print, but that would have been a real pain to remove). I used support lite. Total print time: a bit under 20 hours