OMP M2 Rear UC & XM++ Receiver Holder

thingiverse

Afternoon All. Due to some worry about the odd signal loss with the supplied FHSS receiver, which I think might simply be due to the aerial type or position within the model, I wanted to swap RX's and move it away from the main ESC/FBL at the same time. So I fired up the 3D printer when it wasn't needed for my charge case builds and made this variation on my front UC supporting bracket. This mounts an XM++ receiver at the rear of the model, safely between the main frames. I then shortened the antenna's so they were more in keeping with the model. I did have a couple of versions before this final one and I might make another which replaces the middle carbon fibre support bridge peice as well, providing support and two other securing points.. But i think this looks nice and neat, only thing left is get out and fly it. Ian Contessa