OnePlus X simple phonecase

thingiverse

After two years of pondering printing an actual phonecase for my reliable OnePlus X, I finally devoted time to modeling one. The fit is remarkably snug and I strongly recommend scaling up the model if you're printing with ABS, which is likely a good choice anyway. Support may be beneficial but isn't strictly necessary if your printer handles bridging effectively. EDIT: It turns out I'm unable to use a caliper... the icon cutout didn't align with the actual icon. I rectified this in V2. Additionally, I discovered that you can increase the case's snugness by heating up the corner pieces with a lighter for a second and bending them inward over the phone. You won't be able to remove your phone without damaging the case, but hey - just print another one... they're like 30 cents in material.