Onewheel Pint Rear Guard

thingiverse

I drew up this protective plate for the rear of the pint after feeling kerb drops were going to leave a mark. It may also fit the front of the board. As I run Sonnywheels on my OW I didnt check however if you decide to print it off would you mind leaving a comment saying if it fits or not? There are two alignment holes for ease of fitting which you'll see if you rotate the STL. Add some hot glue and slap her on. I'll revise the design as I get out and test it. Currently its the first incarnation. EDIT 07/01/21: First incarnation has been tested to destruction and I can report back that it works great. The higher the infill the longer she'll last. PLA held up well and im going to try PETG next. I've decided against trying TPU as although its extremely tough it is also grippy, not ideal for sliding.