Onix

thingiverse

Wild ONIX appeared! The 3D model for this originated from this wonderful site that rips Pokemon models from the various games: http://roestudios.co.uk/project/3d-pokemon-models But then I made it 3D printer friendly! I welcome anyone to make improvements / remixes of this. Pokemon Copyright Gamefreak/Nintendo Pokemon Fans: Check out my Real Working Fully Functional 3D Printed PokeDex Instructions This print was a bit tricky and required a whole lot of supports that were a pain in the Ash to remove. If you can figure out a way to do it with far less supports, I would be delighted to see. I printed this on a FlashForge Creator 1 (based off of the Replicator 1) I used grey ABS and sliced with these settings: 3 layer thick raft. Full Support (YOU MUST USE SUPPORTS WITH THIS MODEL!) 10% Infill 0.2 mm Layer height 3 Shells 40 mm/s feedrate 75 Travel feedrate 230 degree temperature. It took roughly 4 and a half hours to print.