OpenAstroTracker Controller Enclosure

prusaprinters

<p>This is an enclosure to house all of the required electronics modules for the OpenAstroTracker controller.</p><p><a href="https://wiki.openastrotech.com">https://wiki.openastrotech.com</a></p><p>It has standoffs and cut outs for the following:</p><p>1 x MKS Gen L v2.1 Controller Board with 5 x TMC2209 stepper drivers</p><p><a href="https://github.com/makerbase-mks/MKS-GEN_L">https://github.com/makerbase-mks/MKS-GEN_L</a></p><p>1 x Neo6mv2 GPS module plus antenna</p><p><a href="https://components101.com/modules/neo-6mv2-gps-module">https://components101.com/modules/neo-6mv2-gps-module</a></p><p>1 x Arduino 16 x 2 LCD &amp; Key shield</p><p><a href="https://www.jaycar.co.uk/arduino-compatible-2-x-16-lcd-controller-module/p/XC4454?utm_campaign=redirect&amp;utm_source=XC4454r&amp;utm_medium=web">https://www.jaycar.co.uk/arduino-compatible-2-x-16-lcd-controller-module/p/XC4454?utm_campaign=redirect&amp;utm_source=XC4454r&amp;utm_medium=web</a></p><p>5 x GX12 4 pin locking connectors, for the stepper outputs</p><p>1 x Power Jack</p><p><a href="https://www.amazon.co.uk/gp/product/B07QPZTHDK/ref=ppx_yo_dt_b_asin_title_o07_s00?ie=UTF8&amp;psc=1">https://www.amazon.co.uk/gp/product/B07QPZTHDK/ref=ppx_yo_dt_b_asin_title_o07_s00?ie=UTF8&amp;psc=1</a></p><p>1 x Sliding Switch (for putting the MKS into firmware upload ‘mode’ - see the OAT wiki.</p><p><a href="https://www.amazon.co.uk/gp/product/B00BQLAIW2/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&amp;psc=1">https://www.amazon.co.uk/gp/product/B00BQLAIW2/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&amp;psc=1</a></p><p>&nbsp;</p><p>All of the standoffs accept M3 brass inserts - use shorter (6-8mm) M3 screws on the MKS board and the GPS module. Everything else can use upto 12mm M3 screws</p><p>Print each half to the case with the largest flat side down, and you will not need any support material.</p><p>I printed mine in grey Prusament PETG.</p>