OpenForge 2.0 Dungeon Stone Pillar (Internal Corner) - 1x1 Floor Tile

thingiverse

Remixed from https://www.thingiverse.com/thing:3430710 While printing out a whole pile of OpenForge2 dungeon tiles, I ran into a situation where I needed an inner wall corner, but needed my corner to only take up a 1x1 space - surprisingly, the original files only permit a 2x2 footprint. A quick trip to TinkerCad to shave off the outer 1" floor tiles, and voila - a quick and dirty 1x1 variant that works just fine on a normal 1x1 base with the normal inner corner / pillar part. In keeping with OF2 standards, this is scaled for a 1-inch square base, so print it as-is for a 1"x1" part. If you want it to match 25mm tiles, scale the X and Y by 98.4%; for 1.25" wyloch tiles, scale X and Y by 125%.