OpenHAB Raspberry Pi 4/3 Case

prusaprinters

<p>The OpenHAB Raspberry PI Case is a clean and simple case for a Raspberry that is used as a hub in your smart home system.<br/> Traditional 3D printable cases have normally all ports exposed and therefore always a messy look then there are cables connected.<br/> This case has no visible screws, the cables are leaving the case at only one place at the bottom and it uses a french cleat system for mounting at a wall.</p> <h3>Print instructions</h3><p><strong>Bill of Materials:</strong></p> <ul> <li>8x M3 nuts</li> <li>4x M3X20 screws</li> <li>4x M3X12 screws</li> <li>1x cable tie</li> </ul> <p><strong>Print Instructions:</strong></p> <ul> <li>Supports: No</li> <li>Material: PLA</li> <li>A pause has to be added at 16.50mm for the top of the case to add the nuts to the print</li> </ul> <p><strong>Notes:</strong></p> <ul> <li>I'm printing with an MK2S MMU1, because of that the parts with different colors are single parts. If you have problems to import them: <a href="https://help.prusa3d.com/en/article/importing-multi-material-model_121191">https://help.prusa3d.com/en/article/importing-multi-material-model_121191</a></li> <li>I added to kinds of bottom parts. I personally use a flat LAN cable, but there's also offered one model that should work seamlessly with a round LAN cable</li> <li>The cable tie I used was one that came with my printer</li> </ul> <p>I'm personally using a Raspberry Pi 4 in my case, but a Raspberry Pi 3/3B should fit too.</p>