Openlock Tudor Tiled Roof - Set 2

thingiverse

This is the second set of OpenLock Tudor roof tiles I've made - the first one is https://www.thingiverse.com/thing:3608343 This set fills a gap in what the first set can do; it allows you to make a roof where the end is an even number of tiles wide. It switches the ridge tiles of the first set for narrower ones, with the standard flat roof tile, edges etc then being connected to the new ridge tiles to make your roof. Such a simple thing, and so fiddly to design ! The set consists of 4 pieces, the first two of which are likely to be the most used;; - A rooftop tile, 2 inches wide. - A rooftop end tile with gable section - this will fit on top of two of the gable side pieces from Set 1. - A rooftop end tile without gable section -A small section of gable end; I mainly included it because although it was a "development" piece, I can see it being useful on larger buildings as an internal support. You shouldn't need to add supports to print these pieces, although there are some supports I've built into the designs in the OpenLock ports which you'll need to remove. I usually print with a brim to improve adhesion.