Orange Rx 3 channel S.Bus receiver with long antenna leads holder

thingiverse

If you make one, please post a photo! A nice little protective housing and 90 degree antenna holder for one of the under appreciated but pretty awesome Spectrum compatible Rx units, the 3 channel (14 channel with S.Bus!) this holder has 2 ports for antenna tubes that allow you to easily offset the antennas and holds the tubes VERY tightly. my antenna tubes are 3mm wide. be sure yours are very close to this or you may not get the tubes in. Everything should fit very tight. In order to get the spacings right i had to adjust and re-print several times. (note the picture) My wasted plastic is your gain! Instructions To get your antennas through the small holes you may need to run a string or wire loop in and then put the antenna leads through it, then pull the loop up to get the antenna leads started up the holes. the fit for the receiver is pretty tight but you should be able to get it in without too much force. if you find yourself having to push too hard, re-print this scaled up 1% or something. I'm not responsible for any issues you encounter due to using this item. Use any of my designs at your own risk. Have Fun!