Orbiter extruder 2.0 mount for Prusa Mini

thingiverse

An updated version of the orbiter extruder mount to fit the new 2.0 version. it is also raised to clear the top of the x-carriage so the motor is facing the back. edited in Fusion 360 from the original STL. the screw holes are a very tight alignment but you can bore them out a bit if your tolerances are off slightly Had to select Prusa Mk3s because Mini is not an option still E-steps can be set in the official mini firmware the E-step value is 690 added to starting Gcode as the mini will not save these settings ;start orbiter settings M201 E10000 ;acceleration mm/s2 M203 E120 ;max speed mm/s M205 E5 ;E jerk mm/s M906 T0 E850 ;TMC motor RMS current in mA ;end orbiter settings the official LDO motor runs at 850mA