Orlandoo Hunter or 1/32 diecast car stackable stand

thingiverse

I was running out of room on my Orlandoo shelf and this was my solution. The parts glue together and the units can be stacked. Enjoy. I hope someone gets some use from it :) Main Rack, (self supporting car rack) Glue the Car_stand_Top_latest to the top of "Car_stand_base Latest Extension part. (Rack extension, not self supporting) Car_stand_extension, Sits between two "main rack" assemblies Car stand end. (rack extension with one side supported, use mirror tool to orientate to desired orientation Glue the 2 beam mounts to the top, then glue to the base. *note, Does not require supports *note, at 15% infill its very dependant on the rear supports so it doesn't warp, I recommend printing at a higher infill percentage and allow it to fully cool before removing it from the head bed