OSOYOO 5 Inch DSI Touch Screen Holder

prusaprinters

<p>Great simple design for the Osoyoo 5" touch screen allowing you use easily use Octodash.</p><p>This stand can be used upright or up-side-down allowing a 5-degree tilt or a 51.842-degree tilt.</p><p><strong>Instructions:</strong></p><ol><li>Attach the ribbon cable to the screen</li><li>Slide screen into main_body_print (Note: take note of screen bezel is bigger on the bottom so make sure the 3D printed part is orientated correctly to match screen)</li><li>Press-fit the left_print and right_print to main_body_print ends while feeding the ribbon cable through the right_print slot</li><li>Screw small included screws that come with the screen&nbsp;</li></ol><p><strong>OctoDash Setup:</strong></p><p>Follow Until <strong>Step 4 </strong>and use driver set for 5" screen<strong> </strong><a href="https://github.com/Z-Bolt/OctoScreen/wiki/Installing-OctoScreen-with-a-3.5%22-480x320-TFT-screen">https://github.com/Z-Bolt/OctoScreen/wiki/Installing-OctoScreen-with-a-3.5%22-480x320-TFT-screen</a><strong> </strong>and then install Octodash <a href="https://unchartedbull.github.io/OctoDash/index.html">https://unchartedbull.github.io/OctoDash/index.html</a></p><p>(Note if screen rotated and touch buttons are up-side-down(wrong way) use following code in the \boot\config.txt)</p><pre><code class="language-plaintext">display_rotate=2 lcd_rotate=2</code></pre><p><strong>Print Requirements:</strong></p><ul><li>main_body_print requires a brim to help it stick to the bed if not good luck :)</li><li>Any Layer height</li><li>Any filaments types(not flexible)</li><li>No supports required</li></ul><p>Have Fun :)</p>