OSW Antec ISK600 Parts

thingiverse

These parts are used to construct an Open Sim Wheel (OSW) kit from Ollie Aina. There are three parts: Back Panel, IONI and Voltage Regulator bracket, and Power Supply bracket. Print Settings Printer: OpenBuilds Pegasus 8 Rafts: No Supports: No Resolution: .2mm Infill: 25% Notes: There's nothing particularly difficult to print on these parts. I printed the Back Panel in PLA, but used PETG for the other two. The interior of the case shouldn't get too hot, so PLA should be fine as well, I was just playing with some new filament. Post-Printing Back Panel The back panel has various other parts inserted. The fuse and switch are part of the Ollie Kit. Next is a Neutrik plug and a USB A-B plug, with B on the outside and A on the inside. The upper right is made for a 2-row D-Sub 15 connector, I used a solder connector. The lower right are two XT60 plugs for the enable and e-stop. The plugs I got for this have tabs on them so they can be screwed down. I got them from Hobbyking, http://www.hobbyking.com/hobbyking/store/__81603__XT60_Connector_Male_Female_with_Lock_and_Insulating_Cap_5_pairs_.html. Just make sure to snap off the locking tabs or you'll not be able to unplug the connectors after you plug them in.