Overlord Pro - coroplast arc door frame

thingiverse

Two arcs that create a removable door made mostly of 4mm coroplast. 5x3x20mm neodymium magnets are pushed down the flutes to help affix the door to the frame. The bottom arc has a hook that is profiled to the plastic base of the Overlord Pro and I'm assuming Overlord as well. Parts work as is, but improvements are being made over time. Use http://www.thingiverse.com/thing:945704 to hold the door to the printer. Use the flute spacer to help get the right distance between magnets inside the flutes of the doors. Fan mount comes in two parts and hold an open frame 120mm fan with the use of four 3mmx25mm screws and nuts. Note: I added two fans to one of my doors. The lower fan when using both inner and outer frames, does just barely touch one of the ball joints of the effector on the left side of the printer. So, If you're going to put in a low mounted intake fan, think about your placement and do not use the inner fan mount. Use fender washers instead.