Overlord Pro E3D Chimera/Cyclops Mount

thingiverse

New mount for the E3D Chimera/Cyclops for the Overlord/Overlord Pro 3d printer. Still being worked on, its a bit of a pain to print with nothing really being flat (get working design first, print considerations later...) so you'll end up with lots of random support material underneath. I plan on separating the fan ducts out to separate parts later on, for now its all one piece. Note, the two screw holes under the heatsink fan can't be used - oversight in the design in that the fan for the heatsink is just slightly too close. The other 6 screw holes however are waaay more than needed to hold the thing in place... It doesn't use the Overlord 40x40x20mm stock fans, they were just too big/bulky to mount without printer arms getting close at print extremes. The two nozzle fans take 30x30x10mm fans (same as the Chimera/Cylops heatsink) - note my Chimera came with a 12v fan so had to replace with 24v that the Overlord uses. Mount it with the original screws from the standard Overlord mount (6x M3 8mm), original hostboard screws to the top with 2 more M3 8mm. Nozzle fans mount with 8x (or 4x if you just use two per fan) M3 16mm Print Settings Rafts: Doesn't Matter Supports: Yes Notes: Latest draft was printed using 0.3mm layer height and 0.8mm shell. Has been used for around 20-25 hours of printing with no issues. Post-Printing RC3 with one nozzle attached whilst working on the printer electronics for the 2nd extruder.