OW+/XR Concave footpad

thingiverse

Onewheel plus/XR concave rear footpad. Features: - A mellow concave that runs all the way to the fender (sorry FlightFins users): the whole surface is there for you to enjoy. - Comfortable heel-to-toe concave provides control without messing with your fakie riding. - A pronounced front-to-rear concave ending with a small leap to lock your foot in place without any disgraceful height. - Insert-less design: uses embedded stainless-steel nuts instead, both cheaper and stronger. - Recessed front screws allow for reusing original screws. You can even grip over the front screw holes if you install it on your board first. - A channel to evacuate sideways, rather than on your grip, any water dripping off the fender. - Rounded front corners to prevent lifting off the bed during printing. You will need two standard stainless-steel nuts (either M5 or #10-32, pick the corresponding STL) that will be embedded during print, as well as two slightly longer screws than the originals: contrary to inserts (thread starts at the surface), embedded nut threads start deeper in the pad. Re-use the two original front screws.