P38 Range Rover Chair Adjuster

thingiverse

For some reason my car was missing the hand adjuster for the seat recline on one side. So i roughly modelled it up and created this model. Its my first useful print and its a bit rough round the edges but works ok. Note this .STL is only for half of the adjuster, but it is the half that actually does the work, not the cap. It is the white piece in the photos. Instructions I made this using a reprap prusa mendel and pronterface, bog standard settings for PLA (1.75mm) with heated bed on continuously. I found it would only stick to the glass if i turned on the base layer in the raft settings and also two interface layers.