Pagoda Antenna Cover

thingiverse

This antenna cover is intended to be printed out of TPU. Use an extrusion multiplier of at least 1.15 with a layer thickness of no greater than 0.15 to strengthen the part and prevent holes in the print. Also, print in spiral vase mode with only one outer layer. This cover slips on the bottom of your pagoda antenna, and the variable width of the print clicks it into place around the disks of the antenna, it does not need to be glued into place. It also weighs very little (1.5 grams). The corrugated ridges in the part will help prevent fracturing of the brittle antenna PCB.