Paintball Mask Speed Demon Horns for PUSH UNITE (Maraudr Co DMN-P)

thingiverse

The **DMN-P** are a pair of "Horns" which you can attach to your **PUSH UNITE Paintball Mask** (other masks have not been tested). It increases your speed to up to 150% while only making you 10-15% more cringe (print them in pink for the ultimate speedbonus). **Attaching these will not damage your mask in any way.** They utilise 4 M2x20 screws in total, which secure the mount in place thanks to two bows that bend around the inner curve of the mask. **RECOMMENDED PRINTER SETTINGS:** Layerheight: 0.1-0.2mm Material: PLA / PETG Nozzle Width: 0.4mm Infill: 100% **IMPORTANT: The lower bridge may break if you print it without 100% infill, change this value to something lower at your own caution.** **MAKE SURE** you support the DMN-P properly on your printer-bed: A brim can also help stabilise them on your buildplate. **INSTALLATION:** *Youll need:* - ###**4 M2x20 screws** ### - ###**4 M2 nuts**### ##**Do this for each Horn:**## 1. Prepare the mask: do NOT take out the Visor, it will make it difficult to reattach (Horns slightly overlap the visor) . 2. Place the Horn onto the designated place: it should be placed right next to the fin with the nub sticking out on each side. 3. put the M2x20 Screws through the holes and slide the fitting bridge / bottom onto it. 4. Place the nut over the most inwards screw, and screw it down a little. Do the same afterwards for the most outward one. 5. Pull the screws tight, but be careful to not break the plastic bridge (as soon as you feel resistance, move the screwdriver carefully). The DMN-P should now be in place. If you have questions, are interested in our projects or are looking for more goodies, you can find us under https://maraudr.co ##REMIXES ARE WELCOME!## If use the DMN-P to make your own Horn designs, we'd love to see them! If you enjoy the DMN-P, please leave a comment or a like. If it does not fit your mask, please let us know as well.