PancakeBot Version 1 & Version 2 Gantry Leg

thingiverse

This is a two-part piece for the supporting leg of the PancakeBot Gantry that fits snugly in place. It requires an 8mm ID by 8mm wide bearing, similar to those used in Fidget spinners or Roller Blades. Print the parts separately and secure them with a small wood screw approximately 5 mm in length. Due to the tight fit, you may not need a screw at all. When printing, it's recommended that the large flat top side is facing downwards and no supports are needed, except for the small portion of the wheel hub, which tends to print well due to its slight slope.