Paper clips on wall

prusaprinters

<h3>Paper clips on wall</h3> <p>Paper clip. Attach it to the wall with adhesive tape.</p> <p>It contains two models. That perform the same function different way.</p> <p>These are similar to products called "Tab grabbers".</p> <h3><strong>A</strong> "Paper clip that can be used after printing"</h3> <p>It works fine. It requires less support for printing, and less post processing.</p> <p>Print with the top facing down. You should enable platform (Brim) support.</p> <h3><strong>B</strong> "Paper clip that works with marbles"</h3> <p>It is complex bit more and holds a paper firmly than A. It is easy to remove the paper. Furthermore, the tilt of the paper is also allowed.</p> <p>Install a marble with a diameter of 17 mm. It should be somewhere in your house.</p> <p>Print with both ends up and down. Must need support.</p> <p>--</p> <p>It is better to smooth the surface on which the paper is inserted with a knife or file.</p> Category: Office