Paper Towel Holder Offset (16mm Shelf)

thingiverse

My kitchen cabinet doors stick down past the bottom most shelf, which would clash with the paper towel roll if I went with the original design. I offset the design so that the distance from the shelf edge to the centre of the paper towel roll would be 70mm. I also trimmed the shelf part of the model by 20mm to reduce overall volume. This is model is for a 16mm shelf. EDIT: The holder is a bit flexy with the reduced width, which is fine by me, however for those who may want to print it in it's original width for more stiffness, I've uploaded those STLs too.