Parametric Bed Levelling Calibration Test Object (REMIX)

thingiverse

This prints a small inner square , a small gap and then an outline square. I remixed this to place the squares in the same places as my CR-Touch hits the bed (Why, i am not sure it just feels better) at the same time I changed it so that it allows for differing counts of columns and rows of the printed square This object is designed to help you check that you are correctly levelling your printer bed. It prints nine super thin squares in each corner of you printer bed. If you dont have openscad, just use the Thingyverse customizer **TO USE** * Level your bed, print the object and check the results. * The objects should appear even with a smooth surface. * repeat if needed **REMEMBER** when slicing, your layer height must be equal to or less than the thickness (0.1) otherwise slicing WILL fail