Parametric camera holder. Adjustable tilt angle

thingiverse

Another remix of jnscz's TinyTina 90 mm drone camera holder. Inspired in the "modified camera (tx03)" by Thinner42, but I have coded it from scratch in OpenSCAD, to be able to reduce the tilt angle. The original tilt angle (25 degrees) should be fine for expert pilots. But I am a novice who trains indoors at home, at low speed in stabilized mode. So a smaller tilt angle (10 degrees) is better for me. You can adjust it to fit your needs in the .scad file, along with many other customizable parameters. I have also added two small lateral walls at the bottom of the holder. I adjust their heigth until they reach the bottom of my camera's circuit board. This helps to fix better the camera, preventing unwanted rotation that leads to an unleveled view of the horizon.