Parametric Open Hardware Watch Band

thingiverse

Here is a parametric watch band which can be customised (in Fusion 360 with the parameters tool) for any size watch. No supports are required. I needed a new watch band for a while since my old one disintegrated. I added an Open hardware logo (courtesy of lamer https://www.thingiverse.com/thing:22445) design and did a material swap at the correct height for the coloured pattern. + There are two different Fusion 360 models, one for a straight pin watch and one for a curved pin (mine is curved as seen in the pictures). + If you want to make a watch strap without the pattern, set the **Pattern_thickness** parameter to a very low value (see below). + I have included .stl files for a straight pin, 22mm wide watch band, between 110-155mm length adjustment (excluding the buckle which is about another 10mm). + There is a printed buckle design included which uses a piece of 1.75mm filament for the pin. The filament needs to be 4mm longer than the width of the band e.g. 26mm long for the 22mm band. The filament simply pushes into place and is self retained (see pictures); you will need to cut it with a craft knife to disassemble it. + The loop to hold down the excess strap is also included, and should be added when assembling. + There are small gaps on the edges of the pin holes to ease removal of watch pins. + There is also a small test file to get your TPU quality settings right for the pattern. + The pattern is slightly different to the one shown in the pictures to get the parametric design to work (a bit less pattern on the buckle side strap). + Strange combinations of parameters will cause the model to not generate properly. ##Parameters which can be customised: ###Basic settings: + **CurvedPinDiameter** - For the curved watch pin file only, the diameter of the curve of the watch pins. + **Strapwidth** - The width of the band. + **Linethickness** - The thickness of the pattern lines. + **Straplength1** - The length of the long strap with buckle holes. + **Straplength2** - The length of the shorter strap with the buckle. + **Number_of_holes** - The number of buckle holes. + **Hole_spacing** - The spacing between the buckle holes. + **Hole_position_tweak** - Adjusts the position of the buckle holes. + **Buckle_hole_length** - The length (longer dimension) of the buckle holes, plus a bit more for the rounded ends. + **Buckle_hole_width** - The width of the buckle holes. + **Buckle_pin_width** - The width of the buckle pin, generally should be the same as **Buckle_hole_length**. + **Dot_size** - The size of the dots on the pattern. + **Finish_chamfer** - The size of the chamfer applied around the buckle holes and pin holes. ###Advanced settings: + **Strapbasethickness** - The thickness of the flat base of the band. + **Watch_pin_hole_diameter** - The diameter of the hole for the watch pins. The default 2mm works fine for thin metal pins (approx 1mm in diameter). + **Buckle_pin_hole_diameter** - The diameter of the holes for the buckle pin. The default 2mm works with both a standard thin metal pin and 1.75mm filament for the printed buckle. + **Watch_end_strap_thickness** - The diameter of the strap around the watch pins. + **Buckle_end_strap_thickness** - The diameter of the strap around the buckle pin. + **Pattern_thickness** - The thickness of the pattern on the band. Set this to a very low value e.g. 0.01 if you want the band to print flat without the pattern. + **Strap_clip_width** - The width of the strap loop for holding down the excess strap. + **Pattern_tweak** - Adjusts the position of the pattern on the band. + **Buckle_gap** - The length of the gap for the band to pass through the buckle.