Parametric Replicator Spool Holder - 2

thingiverse

This revised design differs slightly from its predecessor due to a few refined features. The initial model had an issue where both the wall and base of the spool changed according to the spool's diameter, necessitating separate wall pieces for each spool size. To rectify this, I modified the code so that the wall piece and spool base remain fixed in size, allowing various spool parts to fit on a single wall mount, as long as they are smaller than an MBI spool hub. Additionally, I added beveled corners to facilitate easier insertion. For optimal printing results, avoid using support or rafts, and set the layer height at 0.27mm with 10% fill. To prevent cracks in tall prints, ensure your Replicator is closed. The provided wall mount design is for the left side; if you need a right-side version, simply mirror the design using ReplicatorG. If you have experience with other spool sizes, kindly share the source and size details in the comments section.