Parkside X20V Battery Powerbank USB Charger

thingiverse

This is simple DIY powerbank project which combines cheap quickcharge charging module with Parkside 20V battery. Module I used is here (2 ports, affiliate link): https://s.click.aliexpress.com/e/_A4lyx7 Module is great and quickcharge is working like a charm. Tested on Samsung Galaxy 9 and 10. Parts: -Printed parts -4x M3 screw (20mm length) -2x wire terminals -Wires Instructions: 1) Print files (top, middle and bottom) 2) Remove supports. There will be little struggle with supports where front corners of the board goes, as they are just 2 mm high 3) Try to screw the screws, it will be easier later 4) Put wire terminals and place secure them in place, using hot glue 5) Solder other side of the wire to the charger board. Be careful with +- and before soldering put the module in the printed housing 6) Screw the screws :) If you decide to make this thing, please share your work :)