Pc board enclosure with display

thingiverse

This is a 2 line display case with a vertical slot for a pcb. The slots can be knocked out for ventilation if desired. Make sure to trim all pins on the display so that it sits square in opening, it is held in place by the lid trapping it against the posts for the lid screws. So no fixings are needed for the display. Note the display will only fit one way as there's a relief for the backlight on what is the right hand side of the cover. A lexan window can be routed to fit the opening and be cemented in over the display. The depth is 2mm. Perfect for a little arduino project requiring a 2 line iic display on the front. It has two mounting tabs for fixing. Drill and tap the screw holes in the case for the lid screws M4, the lid is already 4mm. Enjoy and let me see what you end up using it for, looking forward to some peer reviews.