Peak Design Mobile Continuity Camera Mount for Apple Studio Display

prusaprinters

<p>A magnetic mount to adapt <a href="https://www.peakdesign.com/pages/mobile">Peak Design's Mobile Case</a> to an <a href="https://www.apple.com/studio-display/">Apple Studio Display</a> for use with <a href="https://reincubate.com/camo/">Reincubate Camo</a> or macOS Ventura's forthcoming <a href="https://support.apple.com/en-us/HT209037">Continuity Camera</a> feature.</p><p>Requires <strong>4x 10mm x 3mm refrigerator magnets</strong> and a suitable pause at the appropriate layer to embed them in the print.</p><p>I recommend you use <a href="https://www.peakdesign.com/pages/mobile">Peak Design's Mobile</a> case and retain the small square boss on the phone side of this adapter – this will make the magnet joint much stronger by preventing sliding in any direction. This <i>should</i> also be compatible with MagSafe natively without a Peak Design case if you remove the boss from the center of the mount, but I haven't tested it.</p><p>My first print so far (GCODE available here) with this design was with:<br>- Prusament PLA Galaxy Silver<br>- 0.15mm layers, QUALITY preset in Prusa Slicer<br>- 4 perimeters<br>- 15% gyroid infill<br>- supports only on the Studio Display clamp/rail<br>- printed with the broadest flat side (faces you on the mount) down on the plate</p>