Pegboard Digital Micrometer Hook
thingiverse
A pegboard hanger for digital micrometers. I think that all theses have close to the same dimensions so it should work well for you. I've pictured it holding my Neiko and a cheapie from amazon. Both hang straight. The hooks have about 33mm of space inbetween and the hooks are offset vertically by 15mm. The holes for the hooks were a little loose in the one I printed and I did have to glue them in. I tightened up the hole tolerance and it should be better. Worst case, they're a little too tight and you may have to file just a little. No supports are needed but you must rotate the base to lay flat. Also, I found that upping the wall count to 3 makes the hooks stronger but I'm sure that standard 0.2mm settings will work. Print the base STL and 2 of the hook STL. I used a small (4mm) brim but I always do to prevent corners from pulling off of the print bed.
With this file you will be able to print Pegboard Digital Micrometer Hook with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Pegboard Digital Micrometer Hook.