Pegboard Mount Paper Towel Holder

thingiverse

This is a paper towel holder to mount to 1/4 inch pegboard with standard 1 inch hole spacing. I've printed two to hold both a roll of heavy duty shop towels, and a roll of standard paper towels to get them off my workbench and out of my way on the pegboard. You will need two of the peg units (pegUnit.stl), and one each of the bar holders. You will also need: - Screw, Socket Head Cap, M4x16 (4x) - Nut, M4 (4x) - Pipe, PVC, 1/2 inch, Schedule 40 (cut to length, will be approximately 12 1/4 inch (311mm) for a standard width paper towel roll) Be careful inserting the peg units into the pegboard; the upper hooked pegs will snap off if you use a lot of force inserting them. If they're too tight, use a round file to open up the holes just a little. While I print these parts at 0.2 mm layer height, I typically refine the area of the upper hooks to a finer layer height to keep the curvature from becoming too jagged. I hope you find this as useful as I have.