Pegboard Power Supply (DPS5005)

prusaprinters

<p>This is a pegboard mounted power supply using a DPS5005 power supply module.</p> <p>This is designed to be as compact as possible, so you don't have a ton of room to work inside. You should wire everything up before you put the module in, since otherwise there is no access. You are able to pop the module back out if needed though.</p> <p>I put a DC jack on the bottom to power the module. The STL does not have a hole for this so you can add/drill whatever sized hole you need for your setup.</p> <h3>Print Settings</h3> <p><strong>Notes:</strong></p> <p>You probably want supports for the back pegs and the front opening. I used custom supports in Cura so that only these areas are supported. If you were to do supports everywhere you'd have no way of getting them out of the center.</p> Category: Electronics