Pentax K1000 Remote Shutter Servo Mount + Case

thingiverse

Designed this mount to attach a small micro servo motor to. The case is to hold a PCB with an Arduino Nano and Raspberry Pi PICO mounted. The circuit that operates it works from an Infrared Signal. You can check out the YouTube video for the project here: https://youtu.be/YhIa19D6slQ materials you need: The parts I used in the test rig were: 1.An Arduino Nano microcontroller 2.A PICO microcontroller 3. 2x Bread boards 4. 5Volt Relay 5. Infrared receiver 6. Servo Motor 7. NPN Transistor 8. 2 LEDs 9. Diode 10. 2x 100 Ohm resistors 11. 1x 15k Ohm resistor 12. 1x 3k Ohm resistor 13. Philips Infrared Remote Control (or any type of infrared transmitting device) 14 Jumper wires males to male and male to female if your planning on only making the breadboard style test circuit 15. USB Cable Tools: Side cutters Soldering Iron Flux cored Solder Flux hot glue gun Multimeter X-ACTO blade 5 Volt power source or 9V battery (if using 9V battery only connect to VIN terminal on Arduino) Electric Drill Drill bit set