Perfect Pads V2

thingiverse

I tweaked the initial prints and added a few enhancements. Print Settings Printer: Da Vinci Jr. 1.0 Rafts: No Supports: Yes Infill: 50% Notes: Layer thickness is 0.2mm To achieve optimal results, I printed these models at a slower pace. Compared to the first attempts, these iterations have turned out significantly better due to two key changes. Firstly, I extended the center shaft by 0.5mm, and secondly, I gave the finger placement area a concave design. However, this redesign comes with a drawback - you'll need to use supports during printing. Despite this requirement, the finished product looks rather neat once cleaned up.