Perforated panel (peg board) reinforced mount system

thingiverse

The system is designed for mounting various instruments on a perforated panel.All models are designed for perforated panels with a hole spacing of 25 mm. This system uses universal fasteners (bars), which are the same for any mounting unit. Only platforms that are mounted on trims differ. On one mounting unit, you need to print two bars. This type of fastening provides greater reliability and durability of the node, and at the same time supports its dismountability without the use of bolts, nuts or any other fasteners. In order for the mounting unit to be durable, printing must be done “sideways” so that the load in the model is not applied between the layers. All models were printed on PETG plastic with very small allowances so that the nodes would be attached very tightly. If after printing the platforms do not “fit” into the trims, then adjust the allowances in the models or just slightly adjust the file or knife.