Philips Avent Connected Baby Monitor mount

prusaprinters

<p>Adjusted to fit a round bar of 24 mm diameter (e.g. for a Snuzpod). Use an M3x25/30 screw + nut to tightly secure the crib attachment. I added some rubber to the platform to prevent the camera from wobbling. Also adjusted the feet for a better fit, and added a compatible M6 hex knob.</p><p>You can print all parts without supports. You might want to print the feet with a slower print speed, as they are quite small.&nbsp;</p><p>For all parts, except the feet, I used:</p><ul><li>Extrudr PLA</li><li>0.3 mm layer height</li><li>0.4 mm line width</li><li>60 mm/s print speed</li><li>100% infill on all parts, cause I don't want them to break ;)</li></ul><p>For the feet, same as above, except:</p><ul><li>0.2 mm layer height</li><li>0.32 line width</li><li>20 mm/s print speed</li></ul><p>Check the source for additional information on the model.</p>