Philips Hue Dimmer Switch Mount for UK light switches

thingiverse

Philips Hue Dimmer switch mounts that are made to fit over UK light switches. The Hue remote is held magnetically to the mount (although on some i've made the fit is close enough that the magnet probably isn't required) and can be removed to give access to the switch behind. I've made versions for a single and a double Hue remote, and to cover a single, double and triple gang light switch. I've been using 15mm diameter x 2mm thick Neodymium magnets, originally I was going to embed them inside during printing but It became too much hassle so i just use a dab of glue to hold them in place. I've found that printing with thicker walls can reduce print times as it's quicker to run a few walls then try and put infill in the thinner sections, but this can increase warping, so experiment to find the balance you like. I've recessed the screws quite far so that you can re-use the existing screws that come on most light switches.