Philips Hue Remote Wall Plate

thingiverse

Philips Hue Remote Wall Plate I was inspired by Jutrasb's printable plate (link below), but I needed one that was a little bigger since I didn't want to repaint the wall, and also I didn't want the screws showing. Since I've been learning Fusion 360, I decided to work on it there, and make some snaps to keep the face plate cover on. It also uses the magnets that came with the original Phillips Hue remote plate, they were still tacky enough when I pried them off the old plate that they stuck to the new plate long enough for me to snap the cover on top which secures them. There are two versions of the face plate available, one with the switch accessible, and one without if like me you just want to leave it on/off all the time. Since I'm still new to Fusion 360, I can't promise that all the features are parametric, and will update properly, but I'm attaching the source if you want to resize it. Or you can check out Jutrasb's version here: https://www.prusaprinters.org/prints/31534-philips-hue-remote-wall-platecradle-with-original-/remixes.